CTS HES-3109 Series User Manual

1
HES-3109 SERIES
9 PORTS 10/100/1000BASE-T ETHERNET MANAGED SWITCH
8 PORTS 10/100/1000BASE-T ETHERNET MANAGED SWITCH
WITH 1 PORT 1000BASE-X UPLINK OR 1 PORT
100/1000BASE-X UPLINK
8 PORTS 10/100/1000BASE-T ETHERNET MANAGED SWITCH
WITH 1 PORT 1000BASE-X UPLINK OR 1 PORT
100/1000BASE-X UPLINK AND TV RF RECEIVER
8 PORTS 10/100/1000BASE-T ETHERNET MANAGED SWITCH
WITH 1 PORT 1000BASE-X UPLINK OR 1 PORT
100/1000BASE-X UPLINK WITH BATTERY CHARGING
FUNCTION
8 PORTS 10/100/1000BASE-T ETHERNET MANAGED SWITCH
WITH 1 PORT 1000BASE-X UPLINK OR 1 PORT
100/1000BASE-X UPLINK WITH BATTERY CHARGING
FUNCTION AND TV RF RECEIVER
Network Management
User’s Manual
Version 1.0

CTS HES-3109 Series Specifications

General

Brand	CTS
Model	HES-3109 Series
Category	Switch
Language	English

Summary

1. Introduction to HES-3109 Series Switches

1.1 Interfaces Overview

Details the physical network interfaces and ports available on the switch models.

1.2 Management Preparations

Guides on connecting the switch and assigning IP addresses for management.

1.3 LED Definitions

Explains the operational status indicated by the device's LED indicators.

1.4 Button Definitions

Describes the functions and operations of the physical buttons on the switch.

2. Command Line Interface (CLI) Management

2.1 Remote Console Management-Telnet

Steps for establishing a Telnet session to manage the switch remotely.

2.2 Navigating CLI Basics

Overview of CLI modes, general commands, and quick key usage.

2.3 Core CLI Commands

Details essential commands for privileged mode and configuration entry.

2.4 Configuration Mode Commands

Covers commands for IP, VLAN, QoS, security, and SNMP configuration.

2.5 Show and Status Commands

Commands to display system information, port statistics, logs, and configurations.

3. Web Management Interface

3.1 System Information Display

View hardware and software details, including firmware version and port count.

3.2 User Authentication Management

Manage user accounts, passwords, and access levels for the web interface.

3.3 Network Management Configuration

Configure IP address, services, time server, and trap destinations.

3.4 Switch Management and Configuration

Configure switch settings, storm control, ports, QoS, VLAN, IGMP, and loop detection.

3.5 Switch Monitoring and Statistics

Monitor port status, traffic counters, SFP info, and MAC address table.

3.6 System Utilities and Maintenance

Perform firmware updates, load factory settings, and view event logs.

3.7 System Operations

Save configuration changes, reset the system, and log out of the interface.

Appendix A: DHCP Auto-Provisioning Setup

A. Setup Procedures Overview

Outlines the steps and network topology for setting up auto-provisioning.

B. Auto-Provisioning Process Flow

Describes the sequence of DHCP messages for firmware and configuration upgrades.