54
3.3.5 Trap Destination
Click the option Trap Destination from the Network Management menu and then the
following screen page appears.
State: Enable or disable the function of sending traps to the specified destination.
Destination: Enter the specific IP address of the network management system that will
receive traps.
Community: Enter the community name of the network management system.
Click the “OK” button to apply the settings.
3.3.6 Trap Configuration
Click the option Trap Configuration from the Network Management menu and then the
following screen page appears.
Cold Start Trap: Enable or disable the Managed Switch to send a trap when the Managed
Switch cold starts.
Warm Start Trap: Enable or disable the Managed Switch to send a trap when the Managed
Switch warm starts.
To Next Page
Loading...
Need help?
General
