Cub Cadet GT1554 VT User Manual

Attach the hose coupler to the water port on your decks 

Turn the water on.4.
5.

position.
6.
7.
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8.
position.


Turn the water off and detach the hose coupler from the 

 
deck.


deck running for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly dry.
Lubrication
WARNING! 

brake, stop engine and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel axles and rims is equipped with a

grease applied with a grease gun after every 25 hours of tractor
operation.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Deck Wheels

a grease fitting. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor
operation.
Parking Brake Adjustment
If the tractor does not come to a complete stop when the brake

roll with the parking brake applied (and the hydrostatic relief

Cadet dealer to have the brake properly adjusted.
Figure 6-2
Figure 6-3
21se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s

Cub Cadet GT1554 VT Specifications

General

Transmission	Hydrostatic
Engine Fuel	Gasoline
Drive	2WD
Deck Type	Fabricated
Front Tire Size	16 x 6.5-8
Cutting Width	54 in (137 cm)
Deck Material	Steel
Turning Radius	18 in (45.7 cm)