EasyManuals Logo

Cub Cadet GT1554 VT User Manual

Cub Cadet GT1554 VT
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Deck Spindle


purpose lithium grease. Using a grease gun, apply two strokes
(minimum) or sufficient grease to the spindle shaft.
Adjustments
WARNING! 
ignition key and engage the parking brake before

heavy gloves when handling the blades.
NOTE: 
any deck leveling adjustments. Refer to Tires on page 25 for
information regarding tire pressure.
Leveling the Deck (Front To Rear)
The front of the cutting deck is supported by a stabilizer bar that
can be adjusted to level the deck from front to rear. The front of
the deck should be between ⁄inch and ⁄inch lower than the
rear of the deck. Adjust if necessary as follows:

the deck lift lever in the top notch.
Rotate the blade nearest the discharge chute so that it is 2.
parallel with the tractor.
Measure the distance from the front of the blade tip to the 
ground and the rear of the blade tip to the ground. The first
measurement taken should be between ⁄inch and ⁄inch
less than the second measurement.
Determine the approximate distance necessary for proper
adjustment and proceed, if necessary.
Loosen (thread outward) the hex lock nut on the end of 

To 2. raise the front of the deck, tighten (thread inward) each
inner hex nut against the front hanger bracket.
To  lower the front of the deck, loosen (thread outward)
each hex nut, away from the front hanger bracket.

Retighten each lock nut against each hex nut when proper 4.
adjustment is achieved.
Adjusting the Seat

adjustment instructions.
WARNING! 
the seat is engaged in the seat-stop. Engage the

back on seat until it clicks into place.
Figure 6-4
Figure 6-5
22 se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet GT1554 VT and is the answer not in the manual?

Cub Cadet GT1554 VT Specifications

General IconGeneral
TransmissionHydrostatic
Engine FuelGasoline
Drive2WD
Deck TypeFabricated
Front Tire Size16 x 6.5-8
Cutting Width54 in (137 cm)
Deck MaterialSteel
Turning Radius18 in (45.7 cm)

Related product manuals