Cub Cadet XR2 1000 - Type C MainZone+SeparatedZone; Type D Main Zone + Sub Zone + Separated Zone; 2 Get Started; Choose locations for the Base Station & Power Supply unit

20 21
Main Zone
Main Zone
Sub Zone
Separated Zone
Separated
Zone
Type D
Main Zone + Sub Zone +
Separated Zone
Some areas of your lawn are
connected to the Main Zone by a
narrow pass (up to 2 m / 7 ft wide)
and some areas are totally separated
from the Main Zone by a fence,
sidewalk, pathway or other obstacle,
and the mower can’t drive between
them.
Type C
Main Zone + Separated Zone
Your lawn consists of two or more
zones that are not connected
(separated by a fence, sidewalk,
pathway or other obstacle). The
mower cannot drive between these
zones.
The Base Station is where your mower recharges, and where the
Perimeter wire starts and ends. In this installation step, you are
going to determine a proper location for the Base Station.
Choose locations for the Base Station & Power
Supply unit
Get
Started
Decide which installation
type is right for you
The Base Station will be installed at a later stage, after the
Perimeter Wire is in place.
TIP
There are two possible ways to install the Base Station:
Inside the lawn
Internal Installation
At a corner
External Installation