Cub Cadet XR2 1000 - 7 Troubleshooting

78 79
Troubleshooting
Message
Displayed
Probable
Cause / Event
Corrective
Action
StOP
(Stuck in place)
The mower got stuck in
place. It cannot continue
driving.
Check the ground for holes or
indentations. Fill it with some earth.
Check if the Perimeter Wire is not
too close to the edge. Move the wire
towards the inner side of the lawn.
Out
(Crossed outside)
The Perimeter Wire is
too close to the edge.
Move the wire towards the inner side
of the lawn.
The lawn slope near
the edge is too big and
causes the mower to slip
outside.
Do not include areas with very steep
slopes.
The lawn’s edge is too
bumpy.
Fill holes and pits along the edge till
level with the ground.
LOOP
(No wire signal)
The Power Supply is
unplugged or there is a
temporary power cut.
Make sure the Power Supply is
connected to the mains supply.
Signal generator may
need to be restarted.
Disconnect the Power Supply from the
mains supply and reconnect after 10
seconds.
Waiting for the perimeter
signal.
Check all power cable connections.
The mower will resume automatically.
The Perimeter Wire is cut. Check for cuts in the Perimeter
Wire.
ELEC
(Check power)
There is a temporary
power cut.
Check main power supply to the
Power Supply.
The Power Supply is not
plugged in properly.
Conrm the Power Supply is plugged in.
There is no charging
source detected.
Clean the charging contacts on the
Base Station and verify proper
connection of the Base Station to the
Power Supply.
Message
Displayed
Probable
Cause / Event
Corrective
Action
LOAd
(Check mowing
height)
The mowing system is
in overload due to very
tall grass or an obstacle
that is stuck or wrapped
around the blade.
Switch o the Safety Switch and
inspect the blades. Remove any
foreign object or excessive clogging
inside the mowing deck.
Raise the mowing height and switch
the TurboMode on.
HrS
(Decrease
inactive time)
Too many Inactive Days
and/or Hours have been
set for your lawn
area.
Decrease the number of Inactive Days
and/or the number of Inactive Hours.
Mowing Frequency is too
high for current settings
of Inactive Time.
Decrease Mowing
Frequency. See “Tell your mower how
often to mow”.
Area setting is too high
for current settings of
Inactive Time.
Decrease area setting.
SEnd
(Sending
operational data)
Wait for the operational
data to be sent via the
GSM module.
No action is required. As soon as
the operational data has been sent,
charging will start. This may take a
couple of minutes.
LIFt
(Lift detected)
Switch off before lifting. It is required to switch O the System
Switch before lifting and carrying the
mower.
OFF
(Switched o)
The mower is
connected to charging,
but switched off.
Switch the System Switch to ‘On’ to
allow charging.
HEAt
(Overheat)
The mowing motor has
been overloaded for too
long.
No action required. The mower will
resume automatically once cooled
down.