62 63
Setting Description
P017 Mobile Communication System
Enable GSM module accessory (if installed).
P018 Statistics On/O
Send operating statistics for diagnostics.
P019 Bluetooth Remote Control Pairing
Pair Remote Control accessory with your mower.
P020 Last Termination Event
Enable special debug mode (by a Service Station).
P021 Program On/O
Enable/Disable automatic operation by zone.
See section 4 further.
P022 Add Sub-Zone
Start the process of adding a sub-zone.
Refer to the“Adding Sub Zones” section of the Installation Manual.
P023 Update Distance to Sub-Zone
Update the distance to the Sub-Zone’s entry point.
This menu option is only shown if a Sub-Zone is dened.
P024 SmartMow On/O
Increase mowing eciency.
May be less ecient with particular lawn shapes.
P025 SmartMow Edge Overlap
Optimize SmartMow mode for your lawn.
P026 Turbo Mow On/O
Enable faster and stronger cut. When the mowing cycle is
completed, this feature is set to o automatically.
P027 RoboHome On/O
Allow proper rain detection when RoboHome is installed.
P028 External Base
Enable and set the distance of an external base installation.
Setting Description
P029 Collision Detection Sensitivity
Set a higher value for a softer collision with objects. May cause
false-detections.
P030 Energy Saver
Minimize power consumption and disable automatic operation
to comply with CEC/DoE regulation. Appears only when Program
is set to O.
P031 Signal Type
Change it to avoid interference with other robotic mowers
around. Must be done inside the Base Station.
(*) This setting is not applicable to models for lawns under 800 m
2
/8600 ft
2
.
To Next Page
Loading...
Need help?
General
