6. Attach the in-frame hydration cover by the
bottom bracket.
7. Ax the required lid on the top tube according
to your choice of set-up.
8.2 Removing the in-frame
hydration
The hydration bladder must be completely emptied
prior to removal. To remove, follow the installation
instructions in reverse order.
8.3 In-frame hydration: cleaning
and care
If used with normal water, SOURCE bladders do not
require special cleaning, drying or emptying.
However, we recommend cleaning the bladder if you
use it with sweetened or isotonic drinks or if it has
been unused for a longer period of time:
1. Disconnect both hoses and remove the closure
from the bladder.
2. Wash the bladder with lukewarm soapy water
and use a soft brush to dislodge any stubborn
residue.
3.
Hang the bladder upside down and leave it to air
dry.
To Next Page
Loading...
