CUDA Series 2840 - Oil Skimmer

35
Maintenance
PROBLEM POSSIBLE CAUSE SOLUTION
MACHINE FAILS TO
START WHEN
“WASHING PARTS”
PROCEDURE IS
FOLLOWED
Main power disconnect is off
Verify that no service is being performed on the
machine, then turn the main power disconnect on.
Lid/door is not closing
properly
Check the lid/door closure safety switch; adjust
if necessary.
Failed lid/door closure safety
switch
Test the lid/door closure safety switch; replace if
necessary (See Adjusting the Lid/Door Safety
Switch).
Failed washer cycle timer
Test the wash cycle timer; replace if necessary (See
Lid/Door Safety Switch).
Pump is not operating
properly
See Pump does not operate properly section.
TURNTABLE
DOES NOT
OPERATE
PROPERLY
Parts are obstructing turntable
rotation
Check for parts obstructing rotation of the
turntable; rearrange if necessary.
Drive chain is not on the drive
pulley
Check drive chain; realign on drive pulley
if necessary.
Turntable motor compression
springs are not installed
Check the turntable motor compression springs;
install if necessary (See Turntable Motor
Assembly).
Blown fuse
Check electrical panel for blown fuse; replace
if necessary.
Failed wash cycle timer
Test the electrical panel to eliminate the possibility of a
blown fuse then contact a licensed electrician or a
service representative to test the
turntable motor.
PUMP DOES
NOT OPERATE
PROPERLY
Low water level in sump Check sump water level; add water if necessary.
Pump intake is plugged
Check pump intake for obstructions; clean out
if necessary.
Pump overload relay is tripped Reset the motor overload relay.
Blown fuse
Check electrical panel for a blown fuse; replace
if necessary.
Line voltage is too low
Contact a licensed electrician to verify that the
line voltage matches unit voltage.
Pump is failed
Test the electrical panel to eliminate the possibility of a
blown fuse then contact a licensed electrician or a
customer service representative to test the pump
motor.
OIL SKIMMER
DOES NOT
OPERATE
PROPERLY
Blown fuse
Check electrical panel for a blown fuse;
replace if necessary.
Cuda 2840 Operator’s Manual 8.930-370.0 - AU