Why Cuenod NC4 Burner does not start after thermostatic closure?
If your Cuenod burner doesn't start after the thermostatic closure and the unit shows no fault, it could be due to a low or missing power supply, so check the voltage source. Alternatively, the unit itself may be defective, requiring a replacement.
What to do if Cuenod NC4 Burner starts up briefly when the power supply is switched on?
If the Cuenod burner starts briefly when you switch on the power supply, the unit might be manually locked. In this case, you should unlock the unit.
Identifies the CUENOD burner models covered: NC4, NC6, NC9 GX107/8A.
Contains instructions for installation, operation, and service of the equipment.
Lists article numbers for CUENOD burner models NC4, NC6, and NC9.
Exploded view of components with position and article numbers for parts.
Lists components with their English names and corresponding part numbers.
Component names provided in multiple languages including Russian, Greek, and Polish.
Diagrams illustrating component placement with associated article numbers for NC4/6 and NC9.
Diagrams illustrating component locations, alongside multi-language descriptive names.
Further component listings in various languages, expanding on previous sections.
Explains symbols used for maintenance, spare, and wearing parts.
Shows electrical connections, boiler, burner, gas train, and key components.
Illustrates detailed electrical and hydraulic systems, including optional components.
Lists components with multi-language names and descriptions, referenced by schematic IDs.
General| Model | NC4 |
|---|---|
| Ignition | Electronic |
| Air Regulation | Mechanical |
| Category | Burner |
| Fuel Type | Natural Gas |
To Next Page
