Accessories 31
Cat. No. 01023095
Check Signal Strength Between the GBE RO Controller and Remote
Check the signal strength once the RO controller and wireless remote are set up.
RUNNING
JAN-01-12 12:01P
1. From the default home screen, press . The screen displays the main menu.
1) GO TO RUNNING
2) GO TO OFFLINE
3) INFORMATION
>4) SETUP
2. Press to scroll to 4) SETUP.
3. Press to select the SETUP menu.
3) POWERON MODE
4) FLUSH MODES
5) ACCESSORIES
>6)DIAGNOSTICS
4. Press to select 6)DIAGNOSTICS.
>1) TST WIRELESS
2) TESTPHONELIN
3) USE DATA PORT
4) TEST APP
5. Press to select 1)TST WIRELESS. The screen displays the wireless test
screen.
WIRELESS TEST
0 / 188
RSSI=5
6. The screen displays the test number and total number of attempts and the re-
ceived signal strength indicator (RSSI). The system will continue to test the signal
strength until you press any button to return to the diagnostics menu.
The signal strength indicator (RSSI) will show a value of between 0 and 8. If the
RSSI is at least 4, then the installation is complete. It the SSI drops below 4, then
it may be necessary to select an alternate location for the wireless remote.
RUNNING
JAN-01-12 12:01P
7. Press to save the settings and return to the home screen.
To Next Page
Loading...
Need help?
General
