1)
The RVC button will only be displayed when reverse gear is engaged.
●
Vehicle load modies the representation of
the guide lines. The width represented by the
lines decreases with vehicle load. Pay special
attention to the surroundings when the in-
side of the vehicle of the luggage compart-
ment are loaded.
●
In the following situations, objects or other
vehicles appear to be further away or closer
than they actually are. Pay special attention:
–
If moving from a at surface to a slope
and vice-versa.
–
If the vehicle is heavily loaded.
–
When the vehicle approaches objects
that are not on the ground surface or that
protrude from it. These objects may be
outside the camera angle when reversing.
Note
●
It is important to take great care and pay
special attention if the driver is not familiar
with the system.
●
The reverse assist reference lines disap-
pear when the rear lid is open.
Shown on the display
Fig.137 Infotainment system display:
guidance lines.
1
Lateral lines: extension of the vehicle (ap-
proximately in its total width) on the road.
2
End of the side lines: approx. 2 m behind
the vehicle on the road.
3
Intermediate line: approx. 1 m behind the
vehicle on the road.
4
Horizontal red line: a safe distance of ap-
prox. 40 cm at the rear of the vehicle on
the road.
Switching the system on and o
●
Reverse assist is connected by a contact
when engaging reverse gear.
●
The system switches o 8 seconds after dis-
engaging reverse gear and immediately after
removing the contact.
●
The camera will stop transmitting images
above the speed of 15 km/h (9 mph) with re-
verse engaged.
In combination with the parking aid plus sys-
tem ›››page176, the camera image will no
longer be displayed when reverse gear is dis-
engaged, and the system will display the op-
tical information provided by the parking aid
system.
It is also possible to hide the reverse assist im-
age:
●
By pressing one of the Infotainment system
buttons on the display.
●
OR: by pressing on the miniature vehicle
shown on the screen.
If you wish to display the rear assist image
again:
●
Disengage and re-engage reverse gear.
●
OR: Press the RVC function button
1)
.
To Next Page
Loading...
