Cupra ATECA 2022 - Page 20

18
Driver information
1)
This will show all data on the display at the same time: distance travelled, average consumption, average speed and autonomy.
–
–
–
Speed warning for winter tyres
If the maximum set speed is exceeded, this is
displayed on the instrument cluster display.
The speed warning can be set in the infotain-
ment system ( > Settings > Tyres)
›››page31.
Compass indication
Depending on the equipment, when the igni-
tion is on, the instrument panel display indi-
cates the direction in which you are driving
with a symbol, e.g. NW for Northwest.
When the Infotainment system is on and there
is no route guidance active, the graphic repre-
sentation of a compass is also shown.
WARNING
Even when the outside temperature is higher
than freezing temperature, some roads and
bridges could be frozen.
●
The “ice crystal symbol” indicates that
there may be a risk of freezing.
●
At outside temperatures above +4°C
(+39°F), there may be ice even when the “ice
crystal symbol” is not on.
●
The outside temperature sensor takes a
guideline measurement.
Note
●
There are dierent instrument panels and
therefore the versions and instructions on
the display may vary. In the case of displays
without warning or information texts, faults
are indicated exclusively by the control warn-
ing lamps.
●
Some indications on the instrument panel
screen may be concealed by a sudden event,
e.g. an incoming call.
●
Depending on the equipment, some set-
tings and instructions can be carried out or
displayed on the infotainment system as well.
●
If there are several warnings at the same
time, the symbols will be displayed one after
the other for a few seconds. The symbols will
stay on until you remove the cause.
●
If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case,
go to a specialised workshop and request a
repair.
Driving data indicator
The driving data display shows a range of driv-
ing data and consumption values.
Change from one display to another
●
Turn the right thumbwheel of the multifunc-
tion steering wheel ›››page26.
Changing memory
●
While in Driving data > General in-
formation press on the multi-function
steering wheel to switch between the 3 memo-
ries
1)
:
Since start: The memory is deleted if
the journey is interrupted for more than 2
hours.
Since refuel: Display and storage of
the journey data and the consumption val-
ues collected. When refuelling, the mem-
ory is deleted.
Long-term: This memory contains travel
data up to a maximum of 19hours and
59minutes or 99hours and 59minutes, or
up to a maximum of 1999.9 km or 9999.9
km. When one of these values is exceeded
(varies depending on the version of the
instrument panel), the memory is deleted.
Delete journey data presets
●
Select the memory that you wish to erase.
●
Keep the button on the multi-function
steering wheel pressed for approximately 2
seconds.