NOTICE
When opening and closing in an emergency,
carefully disassemble components and then
reassemble them carefully to avoid damage
to the vehicle.
Emergency unlocking or locking of
the driver’s door
Fig.50 Driver door lever: hidden lock
cylinder.
Fig.51 Driver's door handle: pry the cover
open.
If the central locking system should fail to op-
erate, the driver door can still be locked and
unlocked by turning the key in the lock.
As a general rule, when the driver door is
locked manually all other doors are locked.
When it is unlocked manually, only the
driver door opens. Please observe the instruc-
tions relating to the anti-theft alarm system
›››page73.
●
Unfold the vehicle key shaft.
●
Insert the key shaft into the lower opening
in the cover on the driver door handle then
remove the cover upwards ›››Fig.51.
●
Insert the key blade into the lock cylinder to
unlock or lock the vehicle.
Special characteristics
●
The anti-theft alarm will remain active when
vehicles are unlocked. However, the alarm will
not be triggered ›››page73.
●
After the driver door is opened, you have 15
seconds to switch on the ignition. Once this
time has elapsed, the alarm is triggered.
●
Switch the ignition on. The electronic immo-
bilizer recognises a valid vehicle key and deac-
tivates the anti-theft alarm system.
Note
The anti-theft alarm is not activated when
the vehicle is locked manually using the key
shaft ›››page68.
Emergency lock of doors without
lock cylinders
Fig.52 Locking the door manually.
To Next Page
Loading...
