Cupra BORN - Page 204

Parking and manoeuvringReverse Assist (Rear View Camera)
203
1
2
3
4
Shown on the display
The system’s functions and representations
may vary depending on the equipment.
Reverse assist functions and symbols
When the reverse assist is connected, you can
make adjustments using the function buttons.
Some adjustments are equipment-dependent.
Exit the current display
Switch to angle parking ››› page 203
Switch to cross traic
Adjust the display: brightness, contrast
and colour.
Switch to park assist ››› page 193
Display/hide the parking aid view
Guide lines
Green horizontal lines: extension of the vehi-
cle.
Yellow lines: vehicle path depending on the
steering angle.
Cross traic
This view helps to monitor traic behind the
vehicle and can be used, for example, when
exiting garages or narrow exits.
Requirements
To park with reverse assist, the following re-
quirements must be met:
•
Do not exceed a speed of approx. 15 km/h
(9 mph).
•
Parking space width: vehicle width + 0.15 m
(without counting the mirrors).
To display a real image, the following require-
ments must be met:
•
The luggage compartment rear door is
closed.
•
The surroundings are on a at surface.
•
The vehicle should not be loaded very heav-
ily at the rear.
Angle parking
Fig. 155 Display on the infotainment system
screen: parking with the reverse assistant.
Key to the ››› Fig. 155:
Finding a parking space
Go to the selected parking space
Centre the vehicle inside the parking
space
Road
Parking space
Lateral boundary of the parking space
Rear boundary of the parking space