EasyManua.ls Logo

Cupra BORN - Page 92

Cupra BORN
343 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Opening and closingKeyless Access system
91
Changing the battery
Remove the key blade from the vehicle key
››› page 90.
Insert the key blade into the slot ››› Fig. 83,
press it in the direction of arrow
1
and detach
the cover by levering it
2
.
Remove the battery from the compartment
with a suitable ne object ››› Fig. 84.
Insert the new battery and press it into the
battery compartment ››› .
Place the cover and press it into the vehicle
key housing until it clicks into place.
WARNING
Swallowing a battery with a 20 mm diameter
or any other button battery can cause seri-
ous and even fatal injuries within a very short
time.
Keep the vehicle key and key fobs with bat-
teries out of reach of children.
If you suspect that someone may have
swallowed a battery, seek immediate medical
attention.
NOTICE
If the battery is not changed correctly, the
vehicle key may be damaged.
Use of unsuitable batteries may damage
the vehicle key. For this reason, always re-
place the dead battery with another of the
same voltage, size and specications.
When tting the battery, check that the
polarity is correct.
For the sake of the environment
Please dispose of your used batteries cor-
rectly and with respect for the environment.
Synchronize the vehicle key
If the button is pressed frequently outside of
the vehicle range, it is possible that the vehicle
can no longer be locked or unlocked using the
key. In this case, the key must be resynchron-
ised as described below:
Stand next to the vehicle.
Briey press the button on the vehicle key
twice.
OR:
Remove the emergency key ››› page 89.
Press the button on the key.
Unlock the vehicle with the emergency key.
Open the driver’s door. If the vehicle is tted
with an anti-theft alarm, it will trigger immedi-
ately ››› page 97.
Switch the ignition on. Please note: to switch
on the ignition, place the vehicle key in the
drink holder or in the central console's storage
compartment ››› page 145.
This completes the synchronization.
Keyless Access system
Unlocking and locking with the
Keyless Access system
Fig. 85 Keyless Access: proximity zones.

Other manuals for Cupra BORN

Related product manuals