INSTALLATION
10
4. The condensation strip must be tted
to the underside of the worktop above
your dishwasher to protect it against any
moisture. Its purpose is to protect your
worktop’s underside from steam rising from
the dishwasher.
• Ensure the surface is clean prior to
sticking the condensation strip to the
underside of the worktop.
• Remove the backing paper from the
condensation strip.
3. Do not connect the unit to the mains socket
before installation. Ensure you are not
installing the unit right in front of the mains
socket. This is to avoid potential damage to
the back of the unit.
• Stick the condensation strip to the
underside of the worktop.
5. The worktop can be removed by removing
the xing screws located at the rear of the
dishwasher. After removing the screws, lift
and push the worktop forward to release
the lugs from the front section of the
dishwasher. The polystyrene block and the
lugs should be saved for future use.
Leave some space
Stick the Condensation Strip
under the worktop, where you
want to install the dishwasher.
Remove
Remove
Remove
Unscrew
Failure to attach the
condensation strip could
result in damage to the
underside of your worktop!
CDW60W_B_S16/A_IB_RC_171116_grace.indd 10 16/11/17 6:08 pm
To Next Page
Loading...
