26
Switching O the Unit
To save energy, remember to switch the dishwasher o using the On/O button. The dishwasher
will turn o automatically after 30 minutes.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip
more easily when they are hot. Therefore, if you open the dishwasher door fully after switching
o, it will allow the dishes to cool down much faster.
Delay Start
The starting time of a washing programme can be delayed and adjusted. Please follow the steps
below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Close the dishwasher door and then press the On/O button to turn on the dishwasher.
3. Select your preferred programme.
4. Set the required delay start time using the Delay button.
5. Press the Start/Pause button. The unit will start the programme at the assigned delay hour
automatically.
Half Load
In case you do not have enough dishes for a full load, the half load option can be selected. This
will save hot water and electricity usage. Please follow the steps below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Close the dishwasher door and then press the On/O button to turn on the dishwasher.
3. Select your preferred programme.
4. Press both
and buttons at the same time.
5. Press the Start/Pause button. The unit will start the programme.
If the dishwasher is not going to be used for a long period of time, e.g., you are going
on holiday, please disconnect the dishwasher from the mains supply and switch o the
water supply.
Unload the lower basket rst, followed by the cutlery basket and then the upper basket.
This will prevent water drops from the upper basket from falling onto the dishes in the
lower basket.
CDW60W_B_S16/A_IB_RC_171116_grace.indd 26 16/11/17 6:08 pm
To Next Page
Loading...