18
Adding Rinse Aid
Rinse aid helps to ensure water does not cling and leave marks on crockery during the drying
phase and helps crockery dry faster after it has been washed. Only pour rinse aid that is for
domestic dishwashers into the reservoir. This model is designed to use liquid rinse aids only.
Please follow the steps below to pour the rinse aid into the storage reservoir, and the amount will
dispense automatically.
1. Turn the cap and open as indicated.
2. When the cap open marking is aligned,
you may lift the cap up.
3. Pour the rinse aid in until the rinse aid
indicator turns completely black in colour
and close the cap.
4. Be careful not to overll the reservoir.
Wipe up any spills.
Adjusting the Rinse Aid Reservoir
The rinse aid reservoir has six settings. Both the recommended
setting and the factory setting is “3”. If the dishes are not
drying properly or are spotted, adjust the dial to the next
higher number until your dishes are spot-free.
rinse aid indicator
• If the water hardness in your area is soft, you may not need rinse aid as it may cause
white lm to develop on your dishes.
• If you decide to use a detergent tablet, you do not need to add rinse aid into the
rinse aid reservoir.
• Rinse aid warning indicator will illuminate when the reservoir is running out of rinse
aid and requires relling.
• Alternatively, you can judge the amount of rinse aid by checking the rinse aid
indicator next to the reservoir cap. When the indicator is black, it means it is full.
When it is clear, it means it is almost empty.
If there is some rinse aid residue left in the washing
compartment or your dishes, turn the rinse aid
dispenser dial to 1.
CDW60W_B_S16/A_IB_RC_171116_grace.indd 18 16/11/17 6:08 pm
To Next Page
Loading...