30
Maintenance After a Prolonged Period of
Non-Operation
If you are not going to use the unit for a prolonged period of time, you are advised to:
1. Disconnect the dishwasher from the mains.
2. Disconnect the dishwasher from the water inlet and drain. Use a suitable receptacle to catch
any residual water in the pipes.
3. Slightly open the door to prevent unpleasant smells building up in the compartment.
4. Ensure the washing compartment of the dishwasher is clean.
Hints and Tips
Technical Problems
Problem Possible Causes Remedy
Dishwasher does not start.
The door is not properly closed. Close the door firmly.
The unit is not connected to the
mains socket.
Connect the mains plug to the mains
socket.
The unit is not switched on.
Press the On/Off button and select a
programme.
Rapid programme indicator
blinking rapidly (blink 5 times
faster than normal operation
blinking)
Water tap is not turned on. Turn on the water tap.
Low water pressure
(<0.04 MPa)
Turn on the water tap and ensure it is in
full position.
Flow meter is broken.
• Disconnect from the mains.
• Disconnect the water inlet.
• Call a qualified technician.
The wire terminals which connect
the flow meter are loose.
Glass programme indicator
blinking rapidly (blink 5 times
faster than normal operation
blinking)
The tank is leaking.
The hose is leaking.
The float switch is broken or PCB
is faulty.
Repairs should only be carried out by a qualied technician in strict accordance with
current local and national safety regulations. Unauthorised or incorrect repairs could
cause personal injury or damage to the unit.
Before calling for service, please refer to the “Technical Problems” and “General
Problems” sections to solve some general problems by yourself.
CDW60W_B_S16/A_IB_RC_171116_grace.indd 30 16/11/17 6:08 pm
To Next Page
Loading...