PAGE 4
Output Control
The output control establishes the maximum
amount of power available to the trailer brakes.
As the output control is moved to the right, more power will be available
to the brakes when the brake pedal is pressed or the manual control is used.
The output control should be adjusted during initial setup, when trailer load
changes, when different trailers are used or to adjust for a change in road conditions.
The output setting is shown on the digital display when a trailer is connected and
the brake pedal is pressed or the when manual control lever is actuated. The output
setting is shown as 0 through 10, with 0 being the minimum and 10 the maximum.
Sync Control
The sync control is located on the right side of the brake control unit and is responsible
for adjusting trailer brake aggressiveness. The trailer brakes become more aggressive
as the switch is moved toward the rear of the tow vehicle.
To view the sync setting on the display, press the brake pedal (trailer must be connected)
and move the sync control slightly. The display will change to the sync mode.
The sync setting is shown as 1 through 9, with 1 being the least aggressive and 9 being
the most aggressive. The sync adjustment has no effect on the manual control. The sync
control should be adjusted for individual driver preference or changing road conditions.
To Next Page
Loading...
Need help?
General
