INSTALLATION INSTRUCTIONS II5
CAFE, INSTALLATION INSTRUCTIONS 121217B
Powering Up the Brewer
6 Connect the power cord to the electrical outlet.
7 Make sure that the circuit breaker supplying power to the
brewer is on.
8 Some brewers are equipped with a main power switch
on the back or front of the unit. Turn it to the ON position.
9 Depending on the water temperature and the electrical
specim cations, the water tank typically requires 20 to 30
minutes to reach operating temperature. When the water
has heated, the READY TO BREW light will come on.
Power Switch (some units)
WARNING: Connect the power cords only to the
appropriate type and size electrical outlet. If the
electrical outlet is not compatible with the power
cords, have it upgraded by a licensed electrician.
Do not modify the power plug. Do not use an
extension cord. Do not use a power cord/plug that is
damaged.
IMPORTANT: When operating the brewer at
elevations higher than 4000 feet (1200 meters),
have a qualim ed installer adjust the thermostat
inside the unit. See the PROGRAMMING GUIDE
section.
Con¿ guration varies,
Export Shown
To Next Page
Loading...
