Curtis D60GT10 User Manual

1
Conventions
WARNINGS – To help avoid personal injury
Important Notes/Cautions – from the factory
Sanitation Requirements
Models Included
 •D60GT10
 •D60GT30
CAUTION: DONOT
connect this brewer to hot
water. The inlet valve is
not rated for hot water.
CAUTION: Please use
this setup procedure
before attempting to use
this brewer. Failure to follow the
instructions can result in injury or the
voiding of the warranty.
Important Safeguards/Conventions
This appliance is designed for commercial use. Any servicing other than cleaning and maintenance should be
performed by an authorized Wilbur Curtis service center.
• DoNOTimmersetheunitinwateroranyotherliquid
• Toreducetheriskofreorelectricshock,doNOTopentoporrearpanel.Nouserserviceableparts
inside. Repair should be done only by authorized service personnel.
• Keephandsandotheritemsawayfromhotpartsofunitduringoperation.
• Nevercleanwithscouringpowders,bleachorharshimplements.
Your Curtis G3 System is Factory Pre-Set and Ready to Go… Right from the Carton.
FollowingaretheFactorySettingsforyourD60GTCoffeeBrewer:
•BrewTemperature=200°F
•BrewVolume=Settodispensingvesselrequirements(60oz)
GenerallytherewillneverbeareasontochangeyourG3programming.However,shouldyouneedtomake
slightadjustmentstomeetyourbrewingneeds,programminginstructionsareprovidedlaterinthismanual.
SystemRequirements:
•WaterSource20–90PSI.Musthaveaminimumowrateof½GPM(preferredowrateis1gpm).
•Electrical:Seeattachedschematicforstandardmodelorvisitwww.wilburcurtis.comforyourmodel.
Equipmenttobeinstalledtocomplywithapplicablefederal,state,orlocalplumbing/electricalcodeshaving
jurisdiction.
SETUP STEPS
Theunitshouldbelevel(lefttorightandfronttoback),locatedonasolidcountertop.Connectawaterline
fromthewaterltertothebrewer.
NOTE:Awaterltrationsystemmustbeusedtohelpmaintaintrouble-freeoperation.Air must be purged
from the cartridge prior to connection to equipment.Inareaswithextremelyhardwater,wehighlyrecom-
mendtheuseofaCurtisapprovedwaterlter.Forourfulllineoflters,gotowww.wilburcurtis.com.
1.A3/8”NPTx1/4”Flareelbowhasbeensuppliedforwaterlineconnection.Useadequatewatertubing,
sized to provide a minimum of ½ GPM.
2.Connecttheunittoanappropriateelectricalpowercircuit.
3.Turnonthetoggle(STANDBY/ON)switchbehindtheunit.Theheatingtankwillstarttoll.Whenthe
waterlevelinthetankrisestothecorrectvolume,theheatingelementwillenergizeautomatically.G3
systemseliminateelementburn-outduetoanunder-lledheatingtank.
4.Theheatingtankwillrequire20to30minutestoreachoperatingtemperature(200°F),indicatedbythe
READY-TO-BREWlight.
5.Priortobrewing,dispense12ouncesofhotwaterthroughthehotwaterfaucet.
6.Brewacycleofatleast12ounces,topurgethewaterlinesofanyairthatmaybetrappedafterlling.
Wilbur Curtis Company, inC.
NSFInternationalrequiresthefollowingwaterconnection:
1. Aquickdisconnectoradditionalcoiledtubing(atleast2xthedepthoftheunit)sothatthemachinecanbe
moved for cleaning underneath.
2. Thisequipmentistobeinstalledwithadequatebackowprotectiontocomplywithapplicablefederal,state
and local codes..
3. Waterpipeconnectionsandxturesdirectlyconnectedtoapotablewatersupplyshallbesized,installed
andmaintainedinaccordancewithfederal,state,andlocalcodes.
ISO9001:2008REGISTERED
WILBURCURTISCO.,INC.
6913WestAccoStreet
Montebello,CA90640-5403
For the latest information go to
www.wilburcurtis.com
Tel:800-421-6150
Fax:323-837-2410
Service Manual, D60GT Coffee Brewer

Curtis D60GT10 Specifications

General

Brand	Curtis
Model	D60GT10
Category	Coffee Maker
Language	English

Summary

Important Safeguards and Conventions

Conventions

Initial System Setup

Setup Steps

Step-by-step guide for connecting water, power, and initial operation of the brewer.

Brewing Process

Brewing Instructions

Quick Start Guide

Overview of initial setup and basic operation for optimal performance.

Universal Control Module (UCM) Programming

Entering Program Mode

Procedure to access the programming menu using an access code.

Configuration Options

Electrical Schematics and Diagrams

Electrical Schematic Overview

Diagram illustrating the electrical connections and components for 120V and 220V models.

Ladder Diagram

Product Warranty Information

Warranty Terms and Conditions

Details limited warranties, conditions, and exceptions for the coffee brewer.

Return Merchandise Authorization