Curtis enGage IV - 2.0 Installation and Configuration; 2.1 Terminal Assignments

2.0 Installation
2.1 Terminal Assignments – Main connector (J1)
Curtis enGage™ IV Manual
page 3
Pin# Function
1 Battery V +
2 Common
3 Sender1 input (R, V, I)
4 Sender2 input (R, V, I)
5 Sender3 input (R, V, I, Frequency*)
6 Sender4 input (R, V, I, Frequency**)
7 Switched Input 1
8 Switched Input 2
9 Switched Input 3
10 Switched Input 4
11 Switched Input 5
12 Switched Input 6
13 Keyswitch Input
14 MOSFET output 1
15 MOSFET output 2
16 MOSFET output 3
17 Range Select V + (BDI
see table in Section 3.0)
18 n/c
19 LCD Heater V +
20 Dimming Control
*Speedometer, Odometer
**Tachometer
Note: Sender 1, 2, 3 and 4 inputs are limited to 60V max. Voltages beyond
that, will damage the instrument.