Curtis enGage IV - 2.2 Mounting and Connectors

2.1 Terminal Assignments – Communications Connector (J2)
Curtis enGage™ IV Manual
page 4
Pin# Function
1 CAN H
2 CAN L
3 GND
4n/c
5 CAN Terminator 1
6 CAN Terminator 2
7n/c
8n/c
9 SCI Rx
10 GND
11 SCI Tx
12 +7V Out (<10mA – unregulated)
2.2 Mounting
Enclosed unit snaps into panel cutout using molded-in fingers. An
optional mounting bracket (Curtis P/N 17644307) can be used for
additionsal support. Module units are attached via screw holes in the
four corners of the PCB.
2.3 Main Connector
20-pin AMP Mini Universal Mate-N-Lok. (Mating connector: AMP
part number 770585-1).
2.4 Communications Connector
12-pin AMP Mini Universal Mate-N-Lok. (Mating connector: AMP
part number 770581-1).