Curtis G3 Series - Page 24

24
User manual Curtis G3 Series Alpha
Software | Control module
Brew Volume Adjustment
 Make sure the LED above button 2 (
) is lit (press
and release button 2 if necessary). Then, with the
LED above button 2 lit, press and hold button 2
again until the Volume Adjustment screen appears
on the display.
 Press buttons 1 (
) or 3 ( ) to adjust the brew
volume up or down. The range is ± 20 ounces.
 Press button 2 (
) again to set and exit.
Warmer Temperature Control
(Factory setting = 90%)
The warmer to be adjusted must be off.
 Press and hold the desired WARMER button until
the power adjustment screen appears.
 Press buttons 1 (
) or 3 ( ) to increase or decrease
power to the warmer. The range is 50% to 100%.
 Press button 2 (
) to set and exit.
 Press the WARMER button again to turn the warmer
off.
Tank Temperature Check
 Press and hold button 3 (
) until the tank
temperature appears on the display.
 Release the button. The display will return to the
main screen after a few seconds.