Curtis G3 Series - Programming Mode and Guide

25
User manual Curtis G3 Series Alpha
Software | Control module
4.1.2 Programming mode
 With unit OFF, press and hold bottom right BREW
button (4).
 Then press and release ON/OFF button. Continue to
hold down BREW button until Enter Code appears.
 Enter 4 digit code.
Factory default = 1-2-3-4.
You are now in the programming mode.
4.1.3 Programming guide
Shown blow are the various programmin options
available in the programming main menu. The icons
that appear vary based on the brewer model selected
under model select.
Curtis
Entering
Programming mode
Enter Code
41 2 3
<Program Menus>
Select
Brew by Volume
Select
Select
Brew by Time
Select
Quality Timer
PulseBrew On/Off
Select
Drip-Out Mode
Select
Select
Temperature
Energy Save Mode
Select
Brew Count Odom.
Select
Select
Brew Count Total
Cold Brew Lock
Select
Master Reset
Select
Service Call
Select
Banner Name
Select
Select
Warmers Auto-Off
P-Maintenance
Select
Beeper On/Off
Select
FreshTrac - Glass
Select
Display Messages
Select
Language
Select
Model Select
Select
Displ. Brew Time
Select
Pre-Infusion
Select
Access Code
Select
Exit
Select
®