Curtis G3 Series - Detailed Programming Options

26
User manual Curtis G3 Series Alpha
Software | Control module
4.1.4 Programming
See the fi rst page of the programming guide for
instructions on accessing each individual menu item.
some menues save and exit automatically when a
parameter is updated. Other menus exit to the previous
menu when a parameter is saved. To exit, press
until
EXIT appears on the display, then press
.
The following options are available:
Brew by Volume - adjusts the amount of coffee
brewed by time rather than by volume (the factory
default is 2.2L). With an empty airpot in place, press
the appropriate BREW button. When the desired
volume is reached, press the same BREW button again
to stop the brew cycle and set the volume.
Brew by Time - adjusts the amount of coffee brewed
by time rather than by volume (the factory default is
3min - 0sec). Once accessed, press
or until the
number of minutes is fl ashing. Then press
repeatedly
to change the number value. Press
or until the
number of seconds is fl ashing. Then press
epeatedly
to change the number value. Press
or until ‚ex‘ is
fl ashing, then, press
to exit.
Temperature - sets the brewing temperature of the
water tank (the factory default is 93°C). The range is
77°C to 97°C. Once accessed, press
or to choose
the desired temperature. Then press
to set and exit.
Energy Save Mode - saves energy during periods
when the brewer is not in use (the factory default is
OFF). When set to ON, the brewer automatically shuts
off two hours after the last brew cycle. Press the ON/
OFF button to return to normal operation. When set to
ON 60°C, the brewer shuts off two hours after the last
brew cycle, but the water tank temperature remains
60°C. Use the ON 60°C setting to reach brewing
temperature faster after periods of non-use.