Curtis G3 Series - Page 27

27
User manual Curtis G3 Series Alpha
Software | Control module
Once accessed, press
or to choose the desired
setting. Then press
to save and exit.
Brew Count Odom - When accessed, this feature
displays the total brew cycles since the odometer was
last reset. Press
to exit or to reset and exit.
Pre-Infusion - sets the brewer Pre-Infusion time
(Pulse brew must be off to access, the factory default
is Disabled). Pre-Infusion increases control of coffee
clarity and extraction. When turned on, the range is 10
to 60 seconds. Once accessed, press
or to choose
the desired setting, then, press
exit. To turn off the
pulse brew mode, choose 0 for the time.
Note
• When Pre-Infusion is ON, Pulse Brew
disappears from the list of menu items.
Quality timer - notifi es the user that the coffee is no
longer fresh by monitoring the amount of time since
the BREW button was last pressed (the factory default
is OFF). When time expires, an audio alarm turns
on and „Quality-Timer“ fl ashes on the display. Once
accessed (
), press or to increase or decrease the
amount of time. The range is Off to 120 minutes
(2 hours). Press
to set and exit.
Brew Count Total - when accessed, displays the total
brew cycles on the brewer. It cannot be reset. The
display returns to the previous screen automatically
after a few seconds.
Cold Brew Lock - adjusts the temperature at which
the brewer will brew coffee when the BREW button
is pressed (Ready to brew appears on the display, the
factory default is 8°C). This feature also adjusts the
temperature at which the heating element turns on
to reheat the water in the tank. The available settings
NOTE