Curtis G3 Series - Page 28

28
User manual Curtis G3 Series Alpha
Software | Control module
are 3°C, 8°C and OFF. OFF is within 4°C below the
temperature setting. Once accessed, press
or to
choose the desired setting. Then press
to save and
exit.
Master Reset - resets the brewer universal control
module (UCM) to the factory default settings. Once
accessed, “Are You Sure?” will appear on the display.
Press
for Yes or for No.
Service call - sets the service phone number that
appears on the display when the UCM detects a
SENSOR ERROR or WATER ERROR. Once accessed,
press
or to choose the number to be changed.
Then press
repeatedly to change the number value.
Press
or to choose the next number to change or
choose exit and press
.
Access Code - sets the access code entered to access
programming mode (the factory default is 1-2-3-4).
Once accessed, press
or to choose the number to
change. Then press
repeatedly to change the number
value (range is 1 to 4). Press
or to choose the next
number to change or choose exit and press
.
Banner Name - changes the banner name that
appears on the display (the factory default is Curtis).
No banner name appears when all blanks are entered.
Once accessed, press
or to choose the letter to
change. Then press
repeatedly to change the letter
value. Press
or to choose the next letter to change
or choose ex and press
to exit.
P-Maintenance - turns on/off and adjusts the
P-Maintenance (preventive maintenance) brew
monitor (the factory default is OFF). When ON, the
UCM measures the number of liters brewed before
P-Maintenance reminder appears on the display. The
range is Off to 36000L. Once accessed, press
or
to choose the desired setting, then, press
to exit.