Curtis G3 Series User Manual

29
User manual Curtis G3 Series Alpha
Software | Control module
Beeper On/Off - turns the beeper that is heard each
time a button is pressed on or off (the factory default
is ON). Once accessed, press
or to choose the
desired setting. Then, press
to exit.
Pulse Brew - selects the pulse brew pattern
(Pre-Infusion must be off to access, the factory default
is C). The pulse brew pattern selected „tunes“ or changes
the fl avour of coffee. Onc accessed, press
or to
choose the desired setting. Then, press
to exit.
Note
• When Pulse Brew is on, Cold Brew Lock is
set within 3°C and, Cold Brew Lock and
Pre-Infusion disappear from the list of
program selections.
Setting Description
A Starts at beginning of brew cycle. 4
cycles of 10 seconds on and 5 seconds
off, then on until end of brew cycle.
B Starts towards end of brew cycle
(without drip-out mode). 4 cycles of 5
seconds off and 4 cycles of 10 seconds
on. Ends when brew cycle ends.
C Starts at beginning of brew cycle. 5
cycles of 25 seconds on and 10 seconds
off, then on until end of brew cycle.
D Manually set. Starts 30 seconds after
brew cycle starts. Number of pulses is
adjustable from 1 to 10. Pulse on time
and off time are both adjustable from
5 to 60 seconds.
E Manually set. Starts at beginning
of brew cycle. Number of pulses is
adjustable from 1 to 24. Pulse on time
and off time are both adjustable from
1 to 150 seconds.
NOTE

Curtis G3 Series Specifications

General

Brand	Curtis
Model	G3 Series
Category	Brewing Systems
Language	English