Curtis G3 Series User Manual

52
User manual Curtis G3 Series Alpha
Appendix: Technical data
These specifi cations for the electrical connection
and the standards quoted apply for connecting the
coffee machine in EU countries. It may be necessary
to also observe additional country-specifi c
regulations. Outside the EU countries acceptance
of the standards quoted is to be checked by the
legal entity or natural person who wishes to use the
coffee machine.
The customer‘s on-site electrical system must be
designed to meet country-specifi c regulations per
IEC60364and must match the information on the
rating plate.
An isolated ground socket or acountry-specifi c
single-phase socket for single-phase connection,
or a5-pole CEE/CEKON socket per DINEN50310
VDE0800–2-310or acountry-specifi c multi-pole
socket for athree-phase connection, must be
available near the machine. The sockets are part of
the customer‘s on-site installation. The power cord
must not come into contact with hot surfaces. If the
power cord for this device is damaged then it must
be replaced by our service personnel or asimilarly
qualifi ed person, in order to prevent hazards.
In order to avoid possible faults from arising in our shielded data lines due to
potential equalisation currents between the devices, an additional potential
equalisation unit should be planned for devices connected to the vending system
(see DINEN50310 VDE0800–2-310).
If the machine is intended to be installed in alarge kitchen, it is recommended
that it be equipped with aground potential bonding conductor. The potential
equalisation terminal is installed by CurtisService if needed.

Curtis G3 Series Specifications

General

Brand	Curtis
Model	G3 Series
Category	Brewing Systems
Language	English