Curtis G4 Omega Series - Page 8

INSTALLATION INSTRUCTIONS II6
Installation (cont.)
Connect the Brewer Wiring
4 Remove the screws that hold the top panel in place
and remove.
5 If the brewer will be operated using a single phase
power supply:
30 Series Models: The L3 terminal is not used. Connect
the power cable to terminals L1, L2 and GND (2W + G).
Other models (except 38 series): Remove the cap
from the jumper wire attached to the L3 terminal on
the terminal block, then attach the exposed end of the
jumper wire to the L2 terminal (L2 and L3 jumpered).
6 Loosen the strain relief on the back of the brewer.
7 Feed the end of the power cable into the brewer.
8 Connect the wires on the power cable to the terminal
block inside.
9 Tighten the strain relief and replace the top panel.
10 If the power cord will be connected directly to the
junction box, connect the power cable wires to the
terminals in the junction box. See the ELECTRICAL
SCHEMATIC for the power supply requirements.
WARNING: Turn off power to the junction box at the
circuit breaker panel before connecting the power
cable to the brewer. Lock out and tag the circuit
breaker.
&RQ¿JXUDWLRQYDULHV
with model
Rear
panel
Power
cord
Top
View
Terminal
block
Strain
relief
0.&("*/45"--"5*0/*/4536$5*0/4ø 032320C
Power cable from appliance
11 On units with a power plug, connect it to the
appropriate electrical outlet.
continued...
WARNING: Connect the power cord only to the
appropriate type and size electrical outlet. If it is
not compatible, either have the cord replaced or
have the electrical outlet upgraded by a licensed
electrician. Do not use an extension cord. Do not
use a power cord/plug that is damaged.