PROGRAMMING GUIDE PG7
Enabling/Disabling Sleep Mode
The unit must be on (the control panel must be lit) to enable/disable sleep mode.
1 Press the ON/OFF button until the SLEEP light (Źcomes on, then release.
2 1SFTTUIF0/0''CVUUPOBTFDPOEUJNFUPTBWFBOEFYJU
To disable:
1 Press the ON/OFF button until the SLEEP light (Źgoes off, then release.
2 1SFTTUIF0/0''CVUUPOBTFDPOEUJNFUPTBWFBOEFYJU
Setting the Warmer Timer
The unit must be on (the control panel must be lit) and the warmer must be off.
1 Press and hold the WARMER button until the warmer light comes on and goes off. Release the WARMER
button.
2 The warmer light will blink to indicate the amount of time before the warmer shuts off after it is turned on. Each
CMJOLJOEJDBUFTNJOVUFTNJOVUFTNBY
3 "UUIFFOEPGUIFnBTIJOHDZDMFQSFTTBOEIPMEUIF8"3.&3CVUUPOVOUJMUIFXBSNFSMJHIUCFHJOTUPCMJOL
RVJDLMZ5IFnBTIJOHDZDMFXJMMSFQFBU3FMFBTFUIF8"3.&3CVUUPOUPTFMFDUUIFXBSNFSTIVUPGGUJNF
minutes per blink). Selecting 11 blinks disables the timer (the warmer will run continuously until it is shut off
manually using the WARMER button).
4 1SFTTUIF0/0''CVUUPOBTFDPOEUJNFUPTBWFBOEFYJU
WC-760, PROGRAMMING GUIDE 111116NC