Brew Cycle Counter (not resettable)
The brew cycle counter displays the total number of brew cycles on the brewer. It cannot be reset. The display
returns to the previous screen automatically after a few seconds.
1 The rear toggle switch must be in the ON
position. The control panel must be off (power
light off). Press the POWER button if necessary.
2 Press and hold the HALF BREW button. Press
and release the POWER button.
3 Continue to hold down the HALF BREW button
until the READY light TUPQTnBTIJOH, then release the HALF BREW button.
4 5IF3&"%:MJHIUXJMMOPXTUBSUBQBUUFSOPG-0/(BOE4)035nBTIFT5IJTQBUUFSO
JEFOUJmFTUIFOVNCFSPGCSFXDZDMFT4IPSUnBTIFTJOEJDBUFUIFCSFXOVNCFSGSPNPOF
[1] to nine [9]. Long blinks separate the 1’s, 10’s, 1,000’s and 10,000.
5 Press the POWER button to exit.
PROGRAMMING GUIDE PG10
5-1130(3"..*/((6*%&ø /$
Accessing the Pulse Brew Feature (Factory Default = OFF)
1 The rear toggle switch must be in the ON
position. The control panel must be off (power
light off). Press the POWER button if necessary.
2 Press and hold the HALF BREW button. Press
and release the POWER button.
3 Continue to hold down the HALF BREW button
until the READY light TUPQTnBTIJOHBOEDPNFTPOTPMJE, then release the HALF BREW button.
4 5IF3&"%:MJHIUXJMMnBTIBDPEFJOEJDBUJOHUIFDVSSFOUTFUUJOH
Setting #1
Off
Setting #2
Setting #3
READY Light Sequence - Pulse Brew Settings
• Setting #1 provides a pulse of 40 seconds ON, 40
seconds OFF, then ON until the
end of the brew cycle.
• Setting #2 provides a pulse of 30 seconds ON, 5
seconds OFF, repeated four times,
then continuously ON until the end of the brew cycle.
• Setting #3 is 40 seconds ON, 40 seconds OFF, 60
seconds ON, 25 seconds OFF,
then ON until the end of the brew cycle.
Changing the Pulse Brew Setting
1 1SFTTBOEIPMEUIF)"-'#3&8CVUUPOVOUJMUIF3&"%:MJHIUTIPXTPOFRVJDLnBTI5IFCSFXFSIBTKVNQFEUP
the next setting.
2 Repeat Step 1VOUJMUIF3&"%:MJHIUnBTIFTUIFTFRVFODFUIBUSFnFDUTUIFEFTJSFETFUUJOH
3 Press the POWER button to set and exit.
/RQJÀDVK
Legend
6KRUWÀDVK
/RQJÀDVK
Legend
6KRUWÀDVK
POWER
POWER