Step-5. Assemble the 17/12-Meter Reflector using the parts listed below:
[ ] 1 Element Tube, 1-1/8" OD x 84", slotted both ends (MA5BEF)
[ ] 2 Element Tube, 1" swaged to 7/8" x 41-1/2", slotted one end (MA5BEG)
[ ] 2 Element Tube, 7/8" x 13-1/2 " slotted one end, drill other end(MA5BEJ)
[ ] 2 MT2 Trap, 25.9 MHz
[ ] 4 Worm clamp, 7/8" to 1"
[ ] 2 Worm clamp, 1" to 1-1/4"
[ ] 2 7/8" Plastic end cap
17/12-Meter Reflector Assembly
Installation Notes: Double check all work so far against the assembly diagrams before
continuing.
Step-6. Install the HF elements on the boom: If possible, install them with the boom
resting on a flat surface to help you maintain parallel element alignment.
[ ] 4 Element-to-Boom clamp
[ ] 4 U-bolt backing plate
[ ] 4 1-1/2" ID x 3-3/4", 1/4-20 thread SS U-bolt
[ ] 8 1/4-20 Hex nut
[ ] 8 1/4" Split lock washer
To Next Page
Loading...