and the description of device parameters see the following paragraphs.
DEVICE NAME AND
FIRMWARE MODULES
RELEASE
DEVICE
STATUS
KEYS FUNCTIONS
PARAMETERS
FOR DEVICE
CONFIGURATION
PRINTER SETTINGS
PRINTER TYPE ....................................<device model>
PRINTING HEAD TYPE ........................<head model>
INTERFACE ..........................................USB
PROGRAM MEMORY TEST.................OK
CUTTER TEST......................................OK
HEAD VOLTAGE [V] = 24.12
HEAD TEMPERATURE [°C] = 24
POWER ON COUNTER = 4
PAPER PRINTED [cm] = 40
CUT COUNTER = 1
RS232 Baud Rate ........................... : 115200 bps
RS232 Data Length......................... : 8 bits/chr
RS232 Parity ................................... : None
RS232 Handshaking ....................... : Hardware
Busy Condition ................................ : RxFull
USB Address Number ..................... : 0
Print Mode ....................................... : Normal
Autofeed .......................................... : CR Disabled
Chars / inch ..................................... : A=17 B=22 cpi
Code Table [num] ............................ : 00
Font Type......................................... : International
Speed / Quality................................ : Normal
Print Width....................................... : 76 mm
B.Mark Position ............................... : Enabled
B.Mark Threshold ............................ : 40%
B.Mark Distance [mm] ..................... : +00.0
PaperEnd Buffer Clear .................... : Disabled
Antijam Function.............................. : Enabled
T.out Filter [mm]............................... : 08
NPE Delay [cm] ............................... : 000
Printer SetUp Key............................ : Enabled
Page to Page function ..................... : Disabled
Print Density.................................... : 0%
[ PUSH ] to enter setup
[ FAST PUSH ] to skip setup
<device name>
SCODE. <code> - rel 1.00
FCODE. <code> - rel 1.00
30
To Next Page
Loading...
