5.6 Alignment parameters
The parameters marked with the symbol
D
are the default values.
BLACK MARK POSITION Management of the paper alignment:
Disabled
D
= the black mark alignment is not performed
Enabled
= the black mark alignment is performed
BLACK MARK THRESHOLD Threshold value (in percent) for the recognition of the presence of black mark by the
black mark sensor:
30%
D
70%
40% 80%
50% 90%
60%
If the “Black mark position” parameter is disabled, this parameter is not printed.
BLACK MARK DISTANCE “Black Mark Distance” is the minimum distance (in millimetres) between the upper edge
of ticket and the black mark (see
chapter 6).
The numeric value of the distance is made up with the following four parameters for the
setting of three digits (two for the integer part of the number and one for the decimal part)
and of the sign.
If the “Black mark position” parameter is disabled, this parameter is not printed.
BLACK MARK DISTANCE SIGN
Sign setting:
+
D
= positive distance
- = negative distance
BLACK MARK DISTANCE [mm x 10]
Setting the digit for tens:
0
D
2 4 6 8
1 3 5 7 9
BLACK MARK DISTANCE [mm x 1]
Setting the digit for units:
0
D
2 4 6 8
1 3 5 7 9
BLACK MARK DISTANCE [mm x 0.1]
Setting the digit for decimals:
0
D
2 4 6 8
1 3 5 7 9
NOTE:
For example, to set the black mark distance to 15 mm, modify the parameters as follows:
Black Mark Distance Sign = +
Black Mark Distance [mm x 10] = 1
Black Mark Distance [mm x 1] = 5
Black Mark Distance [mm x .1] = 0
37
To Next Page
Loading...
