6 ALIGNMENT
The device is provided with a sensor for the use of alignment black mark in order to handle rolls of tickets with pre-printed
-
6.1 Enable alignment
The sensor can be mounted in one of the six available positions.
on the right,
thermal side
centrally,
thermal side
Sensor mounted
on the left,
thermal side
Sensor mounted
on the right,
non-thermal side
Sensor mounted
centrally,
Sensor mounted
on the left,
To guarantee the correct alignment, you must enable the parameter “Black mark position” during the setup procedure (see
chapter 5).
39
To Next Page
Loading...
