PRINT WIDTH Width of printing area:
52 mm 58 mm 64 mm 70 mm 76 mm
D
54 mm 60 mm 66 mm 72 mm 78 mm
56 mm 62 mm 68 mm 74 mm 80 mm
PAPEREND BUFFER
CLEAR
Disabled
D
portion of the ticket after that the new paper is loaded.
ANTIJAM FUNCTION Setting the sensor for the detection of the paper jam:
Disabled
= Sensor disabled
Enabled
D
= Sensor enabled
TICKET OUT FILTER [mm] Setting the tolerance millimeters to avoid false paper jam messages in case of paper with
back side pre-printed:
0 mm 2 mm 4 mm 6 mm 8 mm
D
10 mm
1 mm 3 mm 5 mm 7 mm 9 mm
NPE DELAY [cm] Setting the delay, expressed in centimetres, in a low paper detecting:
from 0 cm to 999 cm
PRINTER SETUP KEY Setting the option to change the setup parameters at power up:
Enabled
D
PAGE TO PAGE FUNCTION Setting the device behavior after the ticket presentation:
Disabled
D
= the device prints the ticket even though the previous ticket has not been
withdrawn
Enabled = the device prints the ticket only if the previous ticket has been withdrawn
PRINT DENSITY Adjusting the printing density:
-25% 0
D
+25%
-12% +12%
storage to which the thermal paper has been subjected, as well as by the weight of the
same. It may therefore necessary to act on this parameter to obtain the desired print quality.
36
To Next Page
Loading...
