distance” parameter (see paragraph 5.6).
For example, to set a black mark distance of 15 mm between the black mark and the alignment point, the parameters must
be set on the following values:
Black mark distance sign : +
Black mark distance [mm x 10] : 1
Black mark distance [mm x 1] : 5
Black mark distance [mm x .1] : 0
• during the setup procedure of the device (see chapter 5)
• using the tool "PrinterSet"
• in CUSTOM/POS emulation, by using the 0x1D 0xE7 command (for more details, refer to the commands manual)
• by driver
45
To Next Page
Loading...
