Autocutter Chassis
Disconnect the power supply cable and
open the device (see previous paragraphs).
Remove any scraps of paper and the
accumulated paper dust on the input
and the output of autocutter.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
Alcohol, solvent
Disconnect the power supply cable
(see previous paragraphs).
To clean the device,
use compressed air or a soft cloth.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
Alcohol, solvent
1
2
1
2
Disconnect the power supply cable and
open the device (see paragraph 7.1).
Disconnect the power supply cable
(see paragraph 4.1).
52
To Next Page
Loading...
