Custom Built eBikes VLCD-5 - Error Code; Torque Signal Value Display; Initial Value for Torque Signal Display

5.5 Error code
If the system detects a problem, the error code(s) will be displayed where the speed is normally shown.
The error detection systems works when ever the motor is in use.
5.6 Torque signal value display
Press buttons simultaneous for 10 seconds under ODO menu, then only press to
show “ODO”, “TRIP”, “AVG”, “TIME” , “TE” and “TE1” respectively.
Under submenu “TE”, press again, it shows initial torque value, which is for service inspection
use only.
Odometer（ODO） Trip distance（TRIP） Average speed(AVG)
(TE1） （TE） One way time(TIME)
Torque signal value display
5.7 Initial value for torque signal display
Under submenu “TE1”, press again, it shows initial torque value, which is for service inspection use
only. The torque value is normal and the range is between 56 and 102.
ERR-02
HALL
（Motor hall fault or motor short circuit）
ERR-03
Controller failure
ERR-04
Throttle fault)
ERR-08
Low voltage warning
ERR-06
Turn on the motor with cyclist’s feet on the pedal
for coaster brake version