Custom Engineering KPM 216H II - Default Chapter; Table of Contents

To Next Page

To Previous Page

INTRODUCTION

MANUAL CONTENTS ......................................................................................................................................1

EXPLANATORY NOTES USED IN THIS MANUAL .........................................................................................1

GENERAL SAFETY INFORMATION ................................................................................................................1

UNPACKING THE PRINTER ...........................................................................................................................2

PRINTER FEATURES ......................................................................................................................................3

PRINTER DESCRIPTION ................................................................................................................................4

1. INSTALLATION AND USE

1.1 CONNECTIONS ......................................................................................................................................1-1

1.1.1 Power Supply ..................................................................................................................................1-1

1.2 ADDITIONAL BRACKETS ASSEMBLING ...............................................................................................1-2

1.3 SELF-TEST .............................................................................................................................................1-4

1.4 CONFIGURATION ...................................................................................................................................1-5

1.4.1 Ethernet setup .................................................................................................................................1-5

1.4.2 Printer Setup ...................................................................................................................................1-7

1.5 HEXADECIMAL DUMP ...........................................................................................................................1-9

1.6 MAINTENANCE ......................................................................................................................................1-9

1.6.1 Changing the paper roll ...................................................................................................................1-9

1.6.2 Paper load speciﬁ cations ..............................................................................................................1-10

1.6.3 Adjusting paper width ....................................................................................................................1-11

1.6.4 Paper Jam .....................................................................................................................................1-12

1.6.5 Cleaning the printing head ............................................................................................................1-15

1.6.6 Cleaning the ejector rollers ............................................................................................................1-16

1.6.7 Memory card insertion ...................................................................................................................1-17

1.7 TICKET CHARACTERISTICS ...............................................................................................................1-18

1.7.1 Ticket characteristics .....................................................................................................................1-18

2. INTERFACES

2.1 RS232 SERIAL ........................................................................................................................................2-1

2.2 ETHERNET INTERFACE ........................................................................................................................2-3

2.3 USB SERIAL INTERFACE ......................................................................................................................2-4

3. TECHNICAL SPECIFICATIONS

3.1 TECHNICAL SPECIFICATIONS ..............................................................................................................3-1

3.2 DIMENSIONS ..........................................................................................................................................3-4

4. CHARACTER SETS

4.1 CHARACTER SETS IN ESC/POS

EMULATION .................................................................................4-1

4.2 CHARACTER SETS IN SVELTA EMULATION .......................................................................................4-2

APPENDIX A - ACCESSORIES AND SPARE PARTS

A.1 ACCESSORIES ..................................................................................................................................... A-1

A.1.1 Power Supply ................................................................................................................................. A-1

A.2 SPARE PARTS....................................................................................................................................... A-2

A.3 NOTES FOR TECHNICAL ASSISTANCE ............................................................................................. A-2

A.3.1 Replacement of roller motorization belt ......................................................................................... A-2

A.3.2 Replacement control board fuse .................................................................................................... A-3

TABLE OF CONTENTS

User Manual KPM216H II i