Need help?Do you have a question about the Custom Engineering VKP80II and is the answer not in the manual?
General| Print Resolution | 203 dpi |
|---|---|
| Print Speed | 220 mm/sec |
| Paper Type | Thermal paper |
| Paper Width | 80 mm |
| Power Supply | 24 V DC |
| Print Method | Direct Thermal |
| Interface | USB, RS232 |
| Supported Barcode Types | UPC-A, UPC-E, EAN13, EAN8, CODE39, ITF, CODE128, CODE93, CODABAR, QRCODE, PDF417 |
Read and follow all warnings and instructions indicated on the printer.
Details the 2-pin male Molex connector for power supply and its pin configuration.
Explains how printer operating status is indicated in the configuration print-out.
Shows configuration parameters like interface, tests, voltage, temperature, counters, baud rate, and mode settings.
Lists configurable parameters like RS232 Baud Rate, Data length, Parity, Handshaking, Busy condition, etc.
Provides step-by-step instructions for positioning and inserting the paper roll.
Explains how to adjust paper width using left and right slides with reference points.
Guides on cleaning the printer inside by lifting the head/cutter unit.
Details fixing points and screw length considerations for lower printer fastening.
Describes the RS232 interface with a 9-pin female connector and its pin signals.
To Next Page
