Custom Engineering VKP80II - Printer Setup

PRINTER SETUP
INTERFACE ...................................RS232
PROGRAM MEMORY TEST..........OK
DYNAMIC RAM TEST....................OK
EEPROM TEST..............................OK
CUTTER TEST...............................OK
HEAD VOLTAGE [V] = 23,37
HEAD TEMPERATURE [°C] = 25
PAPER PRINTED [cm] = 40
CUT COUNTER = 1
RETRAC COUNTER = 0
POWER ON COUNTER = 4
RS232 Baud Rate .....................: 19200 bps
RS232 Data Length...................: 8 bits/chr
RS232 Parity.............................: None
RS232 Handshaking .................: Xon/Xoff
Busy Condition ..........................: RcFull
USB Address Number
(1)
............: 0
USB Status Monitor
(2)
...............: Disabled
Autofeed....................................: CR Disabled
Print Mode.................................: Normal
Chars / inch ...............................: A=15 B=20 cpi
Speed / Quality..........................: Normal
Paper Retracting .......................: Disabled
Notch Alignment ........................: Disabled
Notch Threshold
(3)
.....................: 2.0V
Notch Distance [mm]
(3)
..............: 00
Current ......................................: Normal
Print Density..............................: 0%
[FF] key to enter setup
[LF] key to skip setup
NOTE:
(1)
This parameter is displayed if the printer has an USB interface; it’s used to identify
univocally the USB printer by a numerical address code, if on the PC are connected
two printers that are the same models for example two VKP80-UE.
(2)
This parameter is displayed if the printer has an USB interface. The Status Monitor
is an additional printing driver component that allows the printer status monitoring. It
must be enabled only if it was installed the Status Monitor specifi c driver.
(3)
If the “Notch Alignment” parameter is “Disabled” this parameter doesn’t appear in the
“Printer Setup” ticket.
(Fig.1.3)
1. INSTALLATION AND USE
User Manual VKP80II 1-3