OPERATIONS
NOTE: This operations section was designed to give instructions on the basic operations of this
jointer. However, it is in no way comprehensive of every jointer operation. It is strongly
recommended that you read books, trade magazines, or get formal training to maximize the
potential of your jointer while minimizing the risks.
WARNING! NEVER PASS HANDS DIRECTLY OVER THE CUTTERHEAD.
WARNING! ALWAYS USE CUTTERHEAD GUARD, PUSH BLOCKS, AND KEEP HANDS
AWAY FROM CUTTERHEAD.
NOTE: THE TIPS ON THE JOINTER WILL NOT WEAR EVENLY BY FEEDING THE WOOD
THROUGH THE SAME SPOT ON THE TABLE EVERY TIME. FEED THE WOOD THROUGH
THE JOINTER AT DIFFERENT SPOTS ON THE TABLE BY REPOSITIONING THE FENCE,
WHEN POSSIBLE, TO HELP ELIMINATE UNEVEN WEAR OF THE TIPS.
STARTING AND STOPPING JOINTER
1. The on/off switch (A) is located on the front of the jointer. To turn the jointer "ON", fully insert
yellow safety key and move switch (A) upwards.
2. To turn the jointer "OFF", move the switch downwards and remove safety key. See FIG 24
WARNING! Remove yellow safety key when unit is not in use to prevent
unauthorized operation
To Next Page
Loading...
