MAINTENANCE (cont.)
5. Place new belt over cutterhead pulley and walk belt onto the motor pulley. Make sure that the
belt is seated in all cutterhead and motor pulley grooves. Pull right side of motor, to begin
tensioning belt, and snug up screw “C”. Do not securely tighten “C” at this time. See FIG 32
6. Pull left side of motor, further tensioning belt, and snug up screw “B”. See FIG 33.
Repeat steps 5 and 6 if belt is not tensioned properly. Once proper belt tension has been
achieved, securely tighten screws “A”, “B” and “C” and replace belt cover.
To Next Page
Loading...
