Page 21 of 42
10. Appliance Cleaning Instructions
Before cleaning the appliance turn off the Fire unit and allow it to cool for a number of hours. Before
using any cleaning materials test a small area first to ensure compatibility with the appliance finish.
CVO Fire cannot be held responsible for damage caused by cleaning the appliance.
Burner Bar / Deposits
It is normal for the burner bar to show a redish or white deposit. This is caused by bi-products of the
gas being burnt and is unavoidable. This can be remedied by using a stove paint like Hotspot High
Temperature Stove Paint which is sold in 100ml cans online for approx £7. Similar products may also
be available from major DIY stores or fireplace retailers. It may be required to paint the burner bar
every 6 months or so depending on usage.
Cleaning the Gas Fire Burner and Enclosure
The most effective method of dust/debris removal is achieved with the aid of a vacuum cleaner
however; great care must be taken to ensure that the pilot assembly is not touched. Using a vacuum
cleaner with a soft brush head gently remove any debris/dust from inside the enclo0sure and around
the burner unit. Once all of the dust and debris has been removed the surfaces can be cleaned with
the use of a soft cloth and a hand held “stainless seel” cleaner which is available from most
supermarkets.
Removing spillages
This appliance has an electronic remote system. Where a liquid has been spilled onto the surface of
the fire or enclosure DO NOT USE THE APPLIANCE – contact your installer to ensure the remote
system functions correctly.
Wax
Never place candles on the burner shelves. If molten wax enters the burner unit – DO NOT USE THE
APPLIANCE - contact your installer to remove the spillage and ensure the remote system functions
correctly.
11. Appliance Servicing Instructions
CVO Fire recommends that the appliance is serviced every 12 months by a registered Engineer.
Step 1: Turn off the appliance and allow it to cool.
Step 2: Turn off the gas supply stop tap.
Step 3: Remove the front shelf and left hand support bracket.
Step 4: Making a note of there positions, remove the Stop Button, Charge Socket
and IR Receiver from the right hand shelf and thread through the aperture in
the burner tray.
Step 5: Turn off the appliance stop tap.
Step 6: Disconnect the gas inlet pipe from appliance stop tap.
Step 7: Remove the four burner fixing screws.
Step 8: Remove the burner from the enclosure.
Step 9: For each injector, remove the two injector holder screws and injector nuts,
then remove and clean the injectors. Do not use a tool that could damage
the injector.
To Next Page
Loading...
