The users must have Read and Understood, but most of all must Respect the directives
described in this manual.
All people coming into contact with the machine on which the numerical control is installed,
whatever their function or whatever state the machine is in (assembly, disassembly, start-up,
production, maintenance, repairs) must have read and understood the requirements
concerning the security and the entirety of the directives of operation described in the
manuals delivered with the machine.
The operator must be properly trained to work with the machine on which the numerical
control is installed. Improper use of the numerical control can cause heavy damage on
equipment and/or injuries to people.
Modification of machine parameters can cause important material damage or lead to
irregular product quality.
Do not expose the numerical control to excessive humidity to avoid any risk of electrocution
and any deterioration of the equipment.
Make sure the numerical control is disconnected from the mains power before carrying out
any cleaning. Do not use liquids based on alcohol or ammoniac.
In case of malfunction of the numerical control, call a technician.
Do not expose the numerical control to direct sun rays or any other heat source.
Do not place the numerical control in the neighbourhood of magnetic equipment such as
transformers, motors or devices which generate interference (welding machines, etc.)
To Next Page
Loading...
Need help?
General
